Please Leave Us A Message
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Electric motorcycle battery is the small heart of electric motorcycle. Its safety, environmental protection and durability are the most important performance for consumers. What kind of electric motorcycle battery is it? How to disassemble and repair the electric motorcycle battery?
Renovate the traditional process of lead-acid batteries and establish a new green environmental protection and energy-saving process.
Because the traditional chemical conversion process is cut off and the main pollution is eliminated, the product is environmentally friendly; the quality is high, the service life is long, the capacity is large; the low temperature start performance is good, and it is especially suitable for use in cold regions in the north. As a power battery, it can be discharged at a high rate; it has a small self-discharge and is suitable for long-term storage; it has obvious cost performance advantages compared with other imported batteries.
1Open the battery cover and remove the 6 helmets.
2 Fill each well with distilled water with a syringe. Above, if you add 1.28 standard electrolyte, the plate may burn out due to excessive acid solubility. For example, when we eat hot pot, why do we eat more salty? That is to say, when water evaporates, salt does not evaporate through water vapor. For the same reason, the acid in the battery will not be evaporated. It's water, so we just need to add about 20-30ml of distilled water to each hole.
3 After filling up, let the battery stand still for half an hour, so that the sponge around the plate fully absorbs water.
Above, then discharge with the resistor, put all the electricity in the battery, no resistance, you can use a 12v bulb instead, such as: motorcycle headlights, car turn signals can be, as long as it can discharge The role of 0v. How to judge that the battery is almost out of power, the cement resistor is discharged at the beginning of the resistor body, slowly and gradually not hot, then the battery will be out of power. If the light bulb is too direct, as long as the light is slowly turned off, it means that the battery discharge is over. The discharge time depends on the capacity of the battery when it is discharged. We can first maintain the battery when it is not powered. This can shorten the discharge time.
4 After the end of the discharge, the battery is charged. It is possible to use the pulse charging method because the pulse charging method can effectively remove the vulcanization of the electrode plate and increase the capacity of the battery. No one can replace it with a car charger.
As shown in the figure: (charge the battery) Take pulse charging as an example.
5 After the charging is completed, use a syringe to withdraw excess water from each well.
A total of 6 holes, completed step by step.
The following is the recommended top ten brand recruitment information for the tricycle industry.
Jiangsu Jinpeng Vehicle Industry Co., Ltd.
February 13, 2023
February 10, 2023
이 업체에게 이메일로 보내기
February 13, 2023
February 10, 2023
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.